Partner ACS R3.0 Pg. 5 - 17 through 5 - 19
Description
Auto Dial buttons can be programmed only on system phones.
This Telephone Programming procedure lets system phone users dial outside
numbers, extension numbers, feature codes, or account codes with a single
touch, by pressing a programmed button. An Auto Dial number can be stored on
any programmable buttons (a button with no line or pool assigned) on a
system phone.
MLS-6, MLC-6, MDC 9000, and MDW 9000 system phones only have four buttons
available for lines, pools, and/or Auto Dial numbers.
Examples
Outside Phone Number. Enter the phone number (up to 28 digits)
exactly as you would dial it. For example, to program 555-2398, press [ 5 ]
[ 5 ] [ 5 ] [ 2 ] [ 3 ] [ 9 ] [ 8 ].
Extension Number. Press the left [ Intercom ] button and enter the
two-digit extension number. Include a [ * ] before the extension number to
program the Auto Dial button to voice signal an extension. For example, to
program extension 20 for voice signaling, press left [ Intercom ] [ * ] [ 2]
[ 0 ]. The display reads: Intercom *20
Feature Code. Enter the appropriate code. For example, to program
a button to turn on the message light at extension 20, press;
[ Feature ] [ 0 ] [ 9 ] [ 2 ] [ 0 ]. When you press the programmed
button, the Message Light at extension 20 turns on.
Programming
To program an Auto Dial button:
- Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [
Central Tel Program ].
- Enter the number of the extension to be programmed.
- Press a programmable button.
- Enter an outside phone number, feature code, account code, or
PBX/Centrex feature access code; or press left [ Intercom ] and enter an
extension number.
- Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit
programming mode.
